Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur

Store

Einleitung

While your Sony Xperia Z5 Compact battery drains quickly after long period of use, you can follow this guide to replace the battery yourself.

  1. Power off and remove SIM card tray. Power off and remove SIM card tray.
    • Power off and remove SIM card tray.

  2. Heat up the back cover to soften the adhesive. Place the suction cup to open a gap from top side, then insert guitar picks and slide it to cut the adhesive underneath. Remove back cover.
    • Heat up the back cover to soften the adhesive.

    • Place the suction cup to open a gap from top side, then insert guitar picks and slide it to cut the adhesive underneath.

    • Remove back cover.

  3. Twist off 10 Phillips screws all. Loosen NFC clip and flashlight clip.
    • Twist off 10 Phillips screws all.

    • Loosen NFC clip and flashlight clip.

  4. Remove the plastic bracket. Pry up and remove back frame. Pry up and remove back frame.
    • Remove the plastic bracket.

    • Pry up and remove back frame.

  5. Remove front camera. Remove front camera. Remove front camera.
    • Remove front camera.

  6. Remove rear camera. Remove rear camera. Remove rear camera.
    • Remove rear camera.

  7. Remove loudspeaker. Remove loudspeaker. Remove loudspeaker.
    • Remove loudspeaker.

  8. Release charging port connector. Remove plastic protective bar. Pry up motherboard assembly from this side. There are three flex connectors connecting the motherboard underneath. So pry up the motherboard assembly gently.
    • Release charging port connector.

    • Remove plastic protective bar.

    • Pry up motherboard assembly from this side. There are three flex connectors connecting the motherboard underneath. So pry up the motherboard assembly gently.

  9. Push audio jack out of the slot, no adhesive underneath. Release LCD flex connector and main flex connector. Separate motherboard assembly from middle housing.
    • Push audio jack out of the slot, no adhesive underneath.

    • Release LCD flex connector and main flex connector.

    • Separate motherboard assembly from middle housing.

  10. Take away NFC antenna on battery. Be aware that the NFC antenna is held by an adhesive and made of thin plastic. Remove it very carefully.
    • Take away NFC antenna on battery.

    • Be aware that the NFC antenna is held by an adhesive and made of thin plastic. Remove it very carefully.

  11. Release battery connector. Pull straight out on the black ends of the battery adhesive strips until they come off. Pry up and remove battery.
    • Release battery connector.

    • Pull straight out on the black ends of the battery adhesive strips until they come off.

    • Pry up and remove battery.

  12. Place the new battery adhesive strips on the motherboard Press the new battery in place
    • Place the new battery adhesive strips on the motherboard

    • Press the new battery in place

    • Follow all the steps in reverse to reassemble your phone

    As of Jan 2018, the battery adhesive strips are not in the parts list above. (Maybe they were at one time, but are no longer available?) I used some very small 3M Command hook adhesive strips instead.

    MR66 - Antwort

Abschluss

To reassemble your device, follow these instructions in reverse order.

20 weitere Nutzer haben diese Anleitung absolviert.

Witrigs

Mitglied seit: 24.11.2015

65.438 Reputation

386 Anleitungen geschrieben

Will the device boot up with no error message after replacing it with new battery? Or do you need some programming before or after replacing it?

Christian Duane Co - Antwort

There is no error when battery is changed.

Just successfully changed my battery without any issue. Booted up normally and able to do everything I was able to do before.

Thank you for the awesome guide :)

DANIEL SOESILO -

The Sony Experia Z5 Compact is water and dust proof. Will heating the back after putting it back on reseal the phone - or is there another step that needs to be added?

Steven Cox - Antwort

You can watch the repair video on youtube: https://www.youtube.com/user/lagaiPhoneS..., but I fixed it here https://lagaiphone.se/shop/sony-z5-compa... they used the adhesive but no water resistant warranty after repair. so far so good!

LagaiPhone -

Pretty annoying, this mentions NOTHING about the battery adhesive strips to order separately, and neither of the “things to buy” come with them. I just replaced my battery, but it’s just flopping around inside at the moment. Where do I order the battery adhesive strips to adhere the battery to the motherboard? Note for others doing this too, you NEED the adhesive strips separately beside the battery and the back adhesive!

michael - Antwort

Yeah I ran into the same issue, I found them at https://www.teknikdelar.se/mobilreservde... but that's a Swedish company I think. I made a suggested edit to this post, suggesting the need for strips to be at least mentioned but I got a reply of “just use some tape".

See Hy -

It doesn't work for me. Connected the battery as it was and can't get it started and now I'm screwed. Such a waste.. What could possibly be wrong?

Morgan Westerlund - Antwort

Thanks so much for this guide… and people who have commented for extra tips like the battery strips!

Phone booted up perfectly and everything seems to be working. Thrilled that I should have some extra time with my phone before having to get a new one.

All in spent around £10 - Took me about 2 hours to do but I’ve never done anything like this before and some things took me a bit longer to figure out. (I only got one adhesive strip though there are two in there, one seems to be holding okay though.)

I wrote some additional comments for the steps here to help anyone who like me is new to this. (Wasn’t enough characters to do it here.)

https://charana-notes.blogspot.com/2018/...

Charlotte - Antwort

Oh I should have read your comments about the flex cable connectors. :+1:

per.tautorat -

Thank you for this guide, everything worked good for me. I replaced the Camera module and USB connector too,

But I am missing one thing in this manual. How to reconnect the flexcables for lcd and mainboard properly? Is there any special trick, i am really thankful that I somehow not destroyed the cable, nor the connector. But I think I was kind of lucky…

per.tautorat - Antwort

Very nice guide!!!

Two things that weren’t immediately clear to me, so maybe useful for others as well:

- Step 2: the back cover is only glued at the edges

- Step 9: the white part of the main and LCD flex connectors turns upwards to unlock it

Stijn Debruyckere - Antwort

I followed everything, and the battery seems to work. A few tips on step 9 would be great, though. But now the display is not showing anything. But it seems the touchscreen still works, I get sounds and vibrations when I press on the parts where the numpad use to be for the decryption of the hard drive. Any Idea on how I could bring this to a full success?

palipalo9 - Antwort

I undertook the battery replacement and put a new charge port in while I was at it.

After putting the phone all back together and powered it up everything appears to work on the screen functions but the phone no longer reads the SIM card or recognises my WIFI. This has rendered the phone unusable. I have tested the SIM in another phone and it is OK. The phone recognises the SIM and does a restart but then does not read the SIM card once it has restarted and displays the message “No SIM card - Emergency calls only”. It is as if the SIM card reader is not working.

I spoke to a technician and he said he wears a wrist band with a wire connected a metal earth to eliminate static electricity in his body going through the phone and short circuiting it causing damage. Could this possibly what has happened to my phone as there was no mention about having the earth yourself while undertaking the battery replacement.

Does anyone have an explanation or solution to my SIM card not reading?

Jason - Antwort

An update on my last post. I managed to get my phone to connect to WiFi but I had to be right next to my modem to get a strong enough signal. Could this mean an aerial problem?

Jason - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzten 24 Stunden: 14

Letzten 7 Tage: 167

Letzten 30 Tage: 679

Insgesamt: 58,031