Introduction

The purpose of this guide to provide simple and straight-forward instruction on replacing a damaged or jammed speed switch.

Parts

No parts required.

  1. Use a phillips head screwdriver to unscrew the following 8 screws:
    • Use a phillips head screwdriver to unscrew the following 8 screws:

      • One 24mm Phillips screw

      • Six 16mm Phillips screws

      • One 9mm Phillips screw

    • Turn the drill to the other side and unscrew the marked screw using the same phillips head screwdriver. Place it with the other removed screws.

    • Keep all screws organized on a magnetic mat after removal.

    Add Comment

  2. Carefully remove the plastic drill casing by pulling it apart.
    • Carefully remove the plastic drill casing by pulling it apart.

    • When separating the drill casing, the black plastic speed switch covering will be removed from the drill automatically.

    Add Comment

    • Gently remove the orange plastic speed switch from the drill. It is located right above the motor.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 4

Past 30 Days: 17

All Time: 465