Einleitung
Step by step instructional guide to replacing Spin Master Hatchimal Draggle speaker. Before getting started, fur and wing removal is required.
Was du brauchst
-
-
-
Use the spudger tool to push up on the black clip to free it.
-
Pull the clip out.
-
-
-
Lift fur up to reveal the next set of clips.
-
Insert a spudger to push up on the black clip to free it.
-
Pull out the clip.
-
-
-
Lift the fur up and over the Hatchimals Head.
-
Remove the six 12mm Phillips #00 screws from then body.
-
-
-
Remove the three 7mm Phillips #00 screws from the head.
-
Remove the wheel base and the circuit board carefully not to damage the spring.
-
-
-
Push the six black fur clips out using the spudger.
-
Remove the fur completely.
-
-
-
Gently pull the yellow speaker cord from circuit board. There will be little resistance.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
USF Tampa, Team S1-G5, Nance Spring 2018 Mitglied von USF Tampa, Team S1-G5, Nance Spring 2018
USFT-NANCE-S18S1G5
3 Mitglieder
10 Anleitungen geschrieben
