Einleitung
Als Werkzeug benötigst du ein Gamebit um das obere Gehäuseteil abzunehmen. Um das Flachbandkabel zum Controller Anschluss zu lösen muss erst die Reset-Taste entfernt werden.
Was du brauchst
-
-
Entferne die sechs 4,5 mm Gamebit Schrauben an der Bodenplatte des Systems.
-
-
-
Drehe das Gerät vorsichtig wieder um.
-
Finde die Nahtstelle und trenne das Gehäuseoberteil vom Unterteil.
-
-
-
-
Hebe die Anschlussbuchsen der Controller aus dem Gehäuse, das sollte mit wenig Kraft gehen. Achte auf das Flachbandkabel.
-
Um dein Gerät wieder zusammen zu setzen folge den Schritten in umgekehrter Reihenfolge.
Um dein Gerät wieder zusammen zu setzen folge den Schritten in umgekehrter Reihenfolge.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
17 weitere Nutzer:innen haben diese Anleitung absolviert.
Besonderer Dank geht an diese Übersetzer:innen:
100%
VauWeh hilft uns, die Welt in Ordnung zu bringen! Wie kann ich mithelfen?
Hier starten ›
Team
Cal Poly, Team 4-47, Amido Fall 2010 Mitglied von Cal Poly, Team 4-47, Amido Fall 2010
CPSU-AMIDO-F10S4G47
4 Mitglieder
25 Anleitungen geschrieben
2 Kommentare
I did a complete teardown of my 26 year old super Nintendo because I had to fix the AV jack. the hardest part was the de soldering. however upon putting it back together I could get the games to play, however it was in black and white…or even a grayish hue…and the controllers didn't work. shortly after the ribbon connecting the controller input to the system snapped on one end. do you think this was the issue, and where do I find a new one? Thanks.
This isn’t complete. How about taking the face plate off?
In order to prevent damage to the fuse, make sure that you always cycle the power before doing so with the power supply disconnected.
Raucedine - Antwort
There is a step missing from these instructions. There are two philips head screws where the AV/Power ports are on the back of the motherboard that need to be removed before you can remove the motherboard itself.
phoenixknight8082 - Antwort
I replaced my controller port, thinking that it was the culprit, but my SNES is still having issues. Nothing works for controller port 1 and only a few buttons work for controller port 2. I tried switching out the controllers and the issue seems to be isolated to the SNES itself. Does anyone have any other suggestions for fixing my issue?
Thanks in advance.
Mike Watts - Antwort
For those facing a black screen on startup (after having cleaned pins on cartridges and cartridge slot) WITH power light coming on, turn off console, remove power, and try shorting out the capacitor leads. My SNES stopped working suddenly after a single power cycle, and shorting out the leads (while UNPOWERED) revived it.
Austin Barnett - Antwort
Could you further explain how to short the capacitor leads?
Will Pulman -