Einleitung
Replace the the gyro on your Syma S107 so that it stops self destructing.
Was du brauchst
-
-
Using tweezers, gently remove the two stabilizing links by pulling straight away from the point of connection.
-
-
-
Remove the gyro carriage by removing the following screws:
-
Two 5.6mm Phillips #0.
-
-
-
-
Gently remove the broken gyro carriage by pulling up.
-
Remove blade assembly by simply sliding it up and off the shaft.
-
-
-
Again using tweezers gently remove the stabilizing links from the blade carriage by pulling straight away from the point of connection.
-
-
-
Remove the blades from the blade carriage by removing the following screws:
-
Two 4.7mm Phillips #0.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
7 weitere Nutzer:innen haben diese Anleitung absolviert.
6 Kommentare
Thank you for this guide! This has fixed the issue and made a 35 year old boy very happy!
Cheers thanks too this page I fixed problem great , Martin
I’m halfway there and grateful for the directions. But I’m not having any luck removing the broken plastic pins from the blade carriage. I’ve tried using a needle but no luck. Did anyone else come up against this?
Now it flies in an oval pattern wat am I doing wrong?