Einleitung

If the rear facing camera on your Toshiba Excite 10 AT300 is now longer functioning, replacement isn't difficult and this guide will give you the step by step procedure. It involves removing a screw, a ribbon cable, and several copper foil wires.

Remove the SD card from the SD card slot.
  • Remove the SD card from the SD card slot.

Kommentar hinzufügen

Use the opening tool to separate the front and rear panels by slipping the tool underneath the screen edge and sliding it around the entire device.
  • Use the opening tool to separate the front and rear panels by slipping the tool underneath the screen edge and sliding it around the entire device.

  • Make sure you unclip all of the clips on the back panel, or pulling it off will be difficult and may damage the tablet.

Kommentar hinzufügen

  • Remove the speaker cable from its socket by gripping both sides of the white connector piece with tweezers and pulling straight out.

  • Be careful not to rip the wires out of the white connector piece.

Kommentar hinzufügen

  • Using a #00 Phillips screwdriver, remove the following screws:

    • Five 3mm Phillips #00 screws

Kommentar hinzufügen

  • Gently lift the battery, pulling away from the tab holding it in place at the bottom.

  • While holding the battery up, use a pair of tweezers to remove the battery cable from its connector.

Kommentar hinzufügen

  • Using a #00 Philips screwdriver, remove the screw attaching daughter board.

  • Remove the yellow tape using a pair of tweezers.

Kommentar hinzufügen

  • Unlock the ribbon cable housing using tweezers and/or a spudger.

  • Gently pull the ribbon cable out of its housing using the tweezers or your hands.

Kommentar hinzufügen

  • Pull copper tape away from the back, keeping it connected to the green rear camera board.

  • Be careful not to rip the copper tape.

Kommentar hinzufügen

  • Using your hands remove daughter board by lifting it off of the tablet chassis. Flip it over and place it next to the tablet face-down.

  • Do not disconnect the red and black wires connecting it to the vibrating mechanism.

Kommentar hinzufügen

  • Gently pinch the ribbon cable connector between two fingers or with tweezers and pull it straight outwards. The ribbon cable connector should disconnect and the camera can now be replaced.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Gus Holz

Mitglied seit 09.10.2014

297 Reputation

2 Anleitungen geschrieben

Team

Cal Poly, Team 14-26, Maness Fall 2014 Mitglied von Cal Poly, Team 14-26, Maness Fall 2014

CPSU-MANESS-F14S14G26

4 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 359