Einleitung

If you have a compatible motherboard, a USB 3.0 port will greatly increase read and write speeds when using a USB stick to access saved files. This guide will show you how to remove your old USB 2.0 cable to make room for your new USB 3.0 cable.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Locate the two sliding locks indicated in the photo.
    • Locate the two sliding locks indicated in the photo.

    • Slide the right lock (labeled "1") to the right. It will remain in the unlocked position.

    • Slide the left lock (labeled "2") to the left and hold it in place.

    Kommentar hinzufügen

  2. While holding the left lock, place your finger in the indentation next to the battery and lift the battery out.
    • While holding the left lock, place your finger in the indentation next to the battery and lift the battery out.

    Kommentar hinzufügen

    • Remove the four screws indicated in the photos using a Phillips 00 Screwdriver. Left to right: 6mm button-head, 3mm flat-head, 6mm button-head, 6mm button-head.

    Kommentar hinzufügen

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • With your hands, grasp the speaker cover on the edge nearest to the screen.

    • Pry the speaker cover upward.

    Kommentar hinzufügen

    • Remove the speaker cover. Your laptop will look like this photo when the speaker cover has been removed.

    Kommentar hinzufügen

    • Locate the screws that are shown in the image.

    • Remove the fourteen 6mm button-head screws with a Phillips 00 Screwdriver.

    Kommentar hinzufügen

    • Lift up on the front cover to remove it.

    There was an additional screw in the front cover to the right of the wireless card that I had to remove; it was already gone in earlier pictures in the walkthrough

    Dylan Carter - Antwort

    • Locate the USB 2.0 cable on the bottom right corner of the laptop.

    Kommentar hinzufügen

    • Locate the white slot on the left side of the USB 2.0 wire.

    • Carefully detach the wire by pulling the cable to the right of the slot.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Curtis

Mitglied seit 18.04.2013

91 Reputation

1 Anleitung geschrieben

Team

Cal Poly, Team 17-6, Regan Spring 2013 Mitglied von Cal Poly, Team 17-6, Regan Spring 2013

CPSU-REGAN-S13S17G6

5 Mitglieder

11 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 5

Insgesamt: 1,016