Einleitung

Before going in and attempting this guide you should have all required materials and tools to properly remove the fan. This may be challenging to be complete. Make sure you follow each step as it is listed.

  1. Unplug the AC adapter and all other auxiliary components from the laptop.
    • Unplug the AC adapter and all other auxiliary components from the laptop.

    • Slide the battery lock tab away from the center of the laptop to unlock the battery.

    Kommentar hinzufügen

  2. Slide the battery release tab away from the center of the laptop and hold it.
    • Slide the battery release tab away from the center of the laptop and hold it.

    • Lifting from the small notch between the two tabs, pull the battery out of the laptop.

    Kommentar hinzufügen

    • Use a PH0 screwdriver to remove the screw holding the optical drive in place.

    • Using your index finger, push the metal tab inside the RAM bay which is located directly underneath the screw-hole.

    • The optical drive will then slide out.

    Kommentar hinzufügen

    • Unscrew the 4 highlighted screws with a PH1 screwdriver.

    Kommentar hinzufügen

    • Orient the laptop so that the screen is open and facing you.

    • Slide the plastic opening tool underneath the top edge of the black plastic insert.

    • Pull it off and set aside.

    Kommentar hinzufügen

  3. Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    • Remove the 2 PH1 screws.

    • Lift the keyboard from the top being carful not to remove it fully. There is still a ribbon cable that connects the keyboard to the laptop.

    Kommentar hinzufügen

    • Disconnect the keyboard ribbon cable and remove the keyboard from the laptop.

    Kommentar hinzufügen

    • Close the laptop and flip it over.

    • Unscrew the 11 yellow circled screws with a PH1 screwdriver. These screws are larger in size.

    • Unscrew the 2 red and yellow circled screws with a PH1 screwdriver. These screws are shorter and thicker than the previous.

    • Unscrew the 1 green and yellow circled screw with a PH1 screwdriver. This screw is longer and thinner than the previous.

    Kommentar hinzufügen

    • Flip the laptop over and open it so that the screen is facing you.

      • Locate the hinges on either side of the screen, which secure the display to the body of the laptop.

      • Unscrew the 2 screws in each hinge with a PH1 screwdriver.

    • The display is no longer connected to the laptop and could fall. Be careful not to drop it during the next steps.

    Kommentar hinzufügen

    • Unfasten the connectors from the highlighted locations.

    • Disconnect by gently pulling on the fasteners which connect the wires to the laptop.

    • Pulling directly on the wires could cause permanent damage to the connectors or the wires themselves.

    • Unscrew the screw indicated by the yellow circle.

    Kommentar hinzufügen

    • Slide the plastic opening tool underneath the edges of the upper casing, which is shown in the images.

    Kommentar hinzufügen

    • The LCD screen can now be removed from the laptop.

    • Lift the upper plastic casing and remove it from the lower half of the laptop.

    Kommentar hinzufügen

    • Unfasten the two connections shown.

    • Unscrew the two screws securing the fan to the laptop. Use a PH1 for the screw that is adjacent to the speaker and a PH0 for the other screw.

    • Lift up the fan and pull the black plastic tab away from the fan housing. Remove the fan.

    • Do not remove the metal fan housing. It is taped to a metal heat-sink and should not be removed.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Youlen

Mitglied seit 11.04.2013

19 Reputation

2 Anleitungen geschrieben

Team

Cal Poly, Team 17-5, Regan Spring 2013 Mitglied von Cal Poly, Team 17-5, Regan Spring 2013

CPSU-REGAN-S13S17G5

4 Mitglieder

6 Anleitungen geschrieben

THANKS , very useful,clear, lifesaver guide !!!

ANDREAS - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 3

Letzte 30 Tage: 10

Insgesamt: 3,322