Zum Hauptinhalt wechseln

Einleitung

This guide will aid in replacing a faulty DC power jack. A faulty power jack will prevent the laptop from conducting a charge.

Ersatzteile

Keine Ersatzteile angegeben.

  1. Using the Phillips Head #0 Screwdriver, remove one 3mm Phillips #0 screw as indicated.
    • Using the Phillips Head #0 Screwdriver, remove one 3mm Phillips #0 screw as indicated.

  2. Remove hard drive cover. Using the Phillips Head #0 Screwdriver, remove seven 3mm Phillips #0 screws as indicated.
    • Remove hard drive cover. Using the Phillips Head #0 Screwdriver, remove seven 3mm Phillips #0 screws as indicated.

  3. Laptop-Akkus

    Wenig Aufwand, große Wirkung.

    Jetzt kaufen

    Laptop-Akkus

    Wenig Aufwand, große Wirkung.

    Jetzt kaufen
  4. Using the Phillips Head #0 Screwdriver, remove twelve 3mm Phillips #0 screw as indicated.
    • Using the Phillips Head #0 Screwdriver, remove twelve 3mm Phillips #0 screw as indicated.

  5. Using the plastic spudger, pry the back off along the periphery  of the laptop. Using the plastic spudger, pry the back off along the periphery  of the laptop.
    • Using the plastic spudger, pry the back off along the periphery of the laptop.

  6. Remove the DC power jack from its plastic retaining piece, just inside of the charger inlet. Remove the DC power jack from its plastic retaining piece, just inside of the charger inlet.
    • Remove the DC power jack from its plastic retaining piece, just inside of the charger inlet.

  7. Use the nylon spudger to remove the connecting wires from the motherboard.  Insert the spudger between the terminal plastic piece of the wire and its retaining clip on the mother board. The wire should release without much force. Use the nylon spudger to remove the connecting wires from the motherboard.  Insert the spudger between the terminal plastic piece of the wire and its retaining clip on the mother board. The wire should release without much force.
    • Use the nylon spudger to remove the connecting wires from the motherboard. Insert the spudger between the terminal plastic piece of the wire and its retaining clip on the mother board. The wire should release without much force.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Patrick Kroenung

Mitglied seit: 12.01.2017

122 Reputation

1 Anleitung geschrieben

Team

Oakland University, Team 2-3, Ruskiewicz Winter 2017 Mitglied von Oakland University, Team 2-3, Ruskiewicz Winter 2017

OAK-RUSKIEWICZ-W17S2G3

4 Mitglieder

7 Anleitungen geschrieben

I got a power jack from seller dcincable.com, it's exactly the same as your images show, but I could not find a service manual, it's great to have your help, thank you so much.

Tom - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 9

Insgesamt: 362