Was du brauchst
-
-
Unscrew the 10 5mm Phillips screws, located on the bottom side of the notebook using the PH1 bit and the Magnetic Driver.
-
-
-
Pry open the bottom cover of the notebook with the plastic spudger tools. Slide a thin tool along the edges without ports to pop open the latches.
-
-
-
-
Remove the 1" yellow tape on top of the battery. This piece of tape is holding down the battery connection cable.
-
-
-
Lightly grip the battery on the two longest sides. Gently pull up until the adhesive on the notebook is separated from the battery.
-
-
-
Unscrew the two 3mm screws with the PH1 screw head on each speaker found on the corner's away from the hinges.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Appalachian State University, Team S2-G3, Menagarishvili Fall 2018 Mitglied von Appalachian State University, Team S2-G3, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S2G3
3 Mitglieder
9 Anleitungen geschrieben
