Einleitung

This guide will provide a walk-through on how to remove the screen in your Toshiba Satellite.

  1. Orient the laptop so that it is closed, faced down, and the battery is facing away from you.
    • Orient the laptop so that it is closed, faced down, and the battery is facing away from you.

    • Slide the unlock switch in the top left-hand corner to the left/unlock position.

    Kommentar hinzufügen

  2. Hold the switch in upper right-hand corner to the right.
    • Hold the switch in upper right-hand corner to the right.

    • With the switch held open, pull the battery straight away from the laptop.

    Kommentar hinzufügen

    • Use the plastic opening tool to remove the four small rubber pop-out squares from the corners of your screen.

    • The laptop displayed in the picture does not have these plastic squares.

    Kommentar hinzufügen

    • Use the Phillips 00 screwdriver to unscrew the four 6.72mm screws from the corners of the screen.

    • The screws will be located underneath the previously removed black squares.

    Kommentar hinzufügen

  3. Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    • Use the plastic opening tool to pop off the black plastic casing that surrounds the screen.

    Kommentar hinzufügen

    • Use the Phillips 00 screwdriver to remove the two 6.72mm screws at the bottom left and right of the screen.

    Kommentar hinzufügen

    • Turn the laptop 90 degrees clockwise.

    • Use the Phillips 00 screwdriver to remove the six 3.78mm screws from both sides of the screen.

    • Hold on to the screen while removing the screws.

    Kommentar hinzufügen

    • Fold the screen down so that the back of the screen is visible.

    • Remove the yellow wiring connected to the top of the back of the screen by pulling it out and then up.

    Kommentar hinzufügen

    • Use the Phillips 00 screwdriver to remove the 5.54mm screw connecting the green panel to the laptop frame.

    Kommentar hinzufügen

    • Pull out the green panel and disconnect the black cable from the belly of the green panel.

    • The screen should be fully disconnected from laptop at this point.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Matthew Trinh

Mitglied seit 31.01.2013

63 Reputation

4 Anleitungen geschrieben

Team

Cal Poly, Team 7-11, Maness Winter 2013 Mitglied von Cal Poly, Team 7-11, Maness Winter 2013

CPSU-MANESS-W13S7G11

4 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 854