Toshiba TDP-XP2 Fuse Replacement

Einleitung

In the rare case of a power surge, if the device is not plugged into a surge protecting outlet, the fuse will blow out and need to be replaced. This guide will show how to tear the whole projector down to get the fuse and replace it.

Was du brauchst

Schritt 1 Fuse

Toshiba TDP-XP2 Fuse Replacement, Fuse: Schritt 1, Bild 1 von 3

Toshiba TDP-XP2 Fuse Replacement, Fuse: Schritt 1, Bild 2 von 3

Toshiba TDP-XP2 Fuse Replacement, Fuse: Schritt 1, Bild 3 von 3

Start by removing the two screws on the bottom of the device as shown.

Übersetzen

Schritt 2

Remove the top plastic cover from the device. The back is snapped on so it would help to have leverage from a prying tool.
Remove the ribbon cable attached to the plastic piece just removed. Remember its orientation for re-assembling later.

Übersetzen

Schritt 3

Toshiba TDP-XP2 Fuse Replacement: Schritt 3, Bild 3 von 3

Remove the screws from the case located around the device.

Übersetzen

Schritt 4

Remove the plastic panels from the body.

Übersetzen

Schritt 5

Toshiba TDP-XP2 Fuse Replacement: Schritt 5, Bild 3 von 3

Remove the screws from the IO panel.
Pull up on the panel and remove it.

Übersetzen

Schritt 6

Unscrew the screws from the metal shielding to remove it.

Übersetzen

Schritt 7

Toshiba TDP-XP2 Fuse Replacement: Schritt 7, Bild 3 von 3

Remove cables from motherboard.
Unscrew motherboard and remove from device.

Übersetzen

How many cables? Can you mark them?

lkmemphis - 1. Mai 2018 Antwort

Schritt 8

Remove the cable from the bottom of the motherboard to fully remove it.

Übersetzen

Does this show the cable removed or not removed? Is it the set of wires encased in blue? Or is it the larger white thingie o the right of the elevated motherboard?

lkmemphis - 1. Mai 2018 Antwort

Schritt 9

Unscrew the power adapter on the back.

Übersetzen

Schritt 10

Remove cables from the power supply board.
Remove the screws located around the board to un-mount it.

Übersetzen

Schritt 11

Locate the fuse near where the power adapter was.
De-solder the fuse and replace with an equivalent fuse (Fuse leads to de-solder are marked in red).

Übersetzen

Will this reference to where the power adapter was be meaningful? Forgive me, but this is like directions that say “turn left at where the A&W used to be”

Is that green panel turned upside down in the second image?

Is that brownish thing the fuse?

lkmemphis - 1. Mai 2018 Antwort