Einleitung

This guide will show you the steps required to remove your charging port.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Make sure the lock switch for the back cover is unlocked.
    • Make sure the lock switch for the back cover is unlocked.

      • The cover is unlocked when the switch is slid in the direction of the 'unlock' icon.

    Kommentar hinzufügen

  2. Remove back cover by prying away from the Thrive.
    • Remove back cover by prying away from the Thrive.

      • The easiest place to pry from is one of the two speakers.

    Kommentar hinzufügen

    • To remove the battery, make sure the lock switch is in the unlocked position.

      • The battery is unlocked when the switch is slid to the unlocked position.

    Kommentar hinzufügen

    • Slide the battery switch release to the right.

      • While holding the switch in place, lift up the battery.

    Kommentar hinzufügen

  3. Kostenloser Versand bei Bestellungen über 20 $
    Verwende den Code BLUEANDBLACK an der Kasse
    Kostenloser Versand bei Bestellungen über 20 $
    Verwende den Code BLUEANDBLACK
    • Start by using a screwdriver to remove the 12 screws holding on the back cover. The screws are 5mm in length and require a PH0 screwdriver.

      • All of these screws are identical so don't worry about getting them mixed up.

    Kommentar hinzufügen

    • Start to gently pry the back of the device off, while leaving it loosely in place.

      • Be careful not to tear or damage the cables when removing the back.

    Kommentar hinzufügen

    • Once the back of the case is off, disconnect the wires by gently pulling on the plastic tabs as shown.

    Kommentar hinzufügen

    • Carefully open the device like a book and lay the two halves beside each other.

    Can you add a picture of somebody opening the device?

    Dan Brown - Antwort

    • Remove the two screws holding the charging port in place. The screws are 3mm in length and require a PH0 screwdriver.

      • Using a pair of tweezers, lift up the charging port's protective covering

    Kommentar hinzufügen

    • Use the tweezers to pull out the connector connecting the charging port to the motherboard.

    • Using the tweezers again, gently lift up the charging port from your Thrive.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

3 weitere Nutzer haben diese Anleitung absolviert.

Kason

Mitglied seit 22.09.2014

977 Reputation

5 Anleitungen geschrieben

Team

USF Tampa, Team 10-1, Brown Fall 2014 Mitglied von USF Tampa, Team 10-1, Brown Fall 2014

USFT-BROWN-F14S10G1

3 Mitglieder

6 Anleitungen geschrieben

I added "better pictures" flag because i was having trouble following the last step cause i couldnt see anything.

Sun Fai Lau - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 3

Letzte 30 Tage: 26

Insgesamt: 3,435