Einleitung

This is a repair guide for battery replacement.

To reach the battery, follow steps 1 through 3 in the Tungsten E Teardown

Kommentar hinzufügen

Begin to pry up the battery.  It is fastened to the mother board using two sided tape.
  • Begin to pry up the battery. It is fastened to the mother board using two sided tape.

  • Caution: the battery is connected by two wires.

Kommentar hinzufügen

Remove the battery
  • Remove the battery

  • Caution: Be careful not to tear the wires when removing battery.

Kommentar hinzufügen

Using a soldering iron, disconnect the battery wires.
  • Using a soldering iron, disconnect the battery wires.

  • Note: the wires are soldered to the board.

Kommentar hinzufügen

Take replacement battery and solder the wires to the board.
  • Take replacement battery and solder the wires to the board.

  • Take care to match wire colors as before.

  • Use double sided tape to attach battery firmly to board.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Kathleen Hix

Mitglied seit 21.01.2010

49 Reputation

2 Anleitungen geschrieben

Team

Cal Poly, Team 13-22, Maness Winter 2010 Mitglied von Cal Poly, Team 13-22, Maness Winter 2010

CPSU-MANESS-W10S13G22

4 Mitglieder

4 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 5

Letzte 30 Tage: 24

Insgesamt: 5,610