Einleitung
A really windy day can break an umbrella. In some cases, a joint will break, disconnecting the stretcher from the rib. You will be using a needle and thread in order to replicate the function of the joint that held the stretcher and the rib together. In addition, this guide will also cover how to sew a small rip on the canopy.
Was du brauchst
-
-
Take the broken part of the stretcher to rib joint.
-
Realign it with the rib assembly.
-
-
-
Take the needle and carefully pass it through one of the holes as seen in the picture.
-
Then pull it back to the same side you went through.
-
-
-
-
Take the needle and pass it through the second hole.
-
Then position the needle so that it faces the first hole from the same side you just went through.
-
-
-
Repeat steps 2-4 until the two pieces are held tightly together.
-
Tie a knot to secure it.
-
-
-
Take the hole, hold each end and pull outward into a line.
-
Take the needle and thread and form a hemming stitch (see Step 7).
-
-
-
Begin with a threaded needle and start the stitch at one end of the hole and pull the needle all the way until just before the thread runs out.
-
Then loop back around and go through again.
-
Repeat until you reach the other end.
-
The umbrella is fixed now, you may now use the umbrella freely.
The umbrella is fixed now, you may now use the umbrella freely.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
DePaul University, Team S1-G8, Dush Fall 2017 Mitglied von DePaul University, Team S1-G8, Dush Fall 2017
DPU-DUSH-F17S1G8
2 Mitglieder
1 Anleitung geschrieben
