Einleitung
Use this guide to remove and replace the power distribution circuit board.
Was du brauchst
-
-
Locate the four plastic screw covers denoted by the markers and gently pry them up with the metal spudger.
-
-
-
Remove the two battery cartridges located on the underside of the camera.
-
Once cartridges are removed, use the metal spudger to pry open the top, bottom, and both sides of the camera.
-
-
-
The device should now be open and ready for further repair and/or replacement parts.
-
-
-
-
Locate and remove the screws circled in the provided image with a Philips #0 screwdriver.
-
-
-
Unsolder the connections to the right battery terminal. Removing the terminal allows easier access to the motherboard.
-
-
-
Carefully pull up on the motherboard and pink plastic underneath the motherboard. The pink plastic contains the display and is connected to the motherboard.
-
-
-
Unsolder the wires connected to the power distribution circuit board.
-
-
-
Locate and remove the two screws that hold in the power distribution circuit board using a Philips #0 screwdriver.
-
-
-
Gently pull up on power distribution circuit board and remove it from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
USF Tampa, Team 6-4, Eyestone Spring 2016 Mitglied von USF Tampa, Team 6-4, Eyestone Spring 2016
USFT-EYESTONE-S16S6G4
4 Mitglieder
5 Anleitungen geschrieben
