Einleitung

This guide will demonstrate how to replace the back cover of the Balance Board.

  1. Flip device upside-down so the plastic white board is facing the ground.
    • Flip device upside-down so the plastic white board is facing the ground.

    • Locate the four feet in the corners of the Balance Board.

    • Unscrew the three 12.7 mm Philips screws from each foot cover.

  2. Remove the grey plastic ring from the actual foot by lifting it up.
    • Remove the grey plastic ring from the actual foot by lifting it up.

  3. Kostenloser Versand für alle Bestellungen über 100 $ oder mit einem Pro Tech Toolkit!

    Schau dich im Store um
  4. Separate the loose foot from the device by lifting it up.
    • Separate the loose foot from the device by lifting it up.

  5. Repeat steps two and three on the remaining four feet.
    • Repeat steps two and three on the remaining four feet.

  6. Unscrew the ten 12.7 mm #1 screws.
    • Unscrew the ten 12.7 mm #1 screws.

  7. Lift off the gray back cover.
    • Lift off the gray back cover.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Cory Olson

Mitglied seit: 29.09.2014

708 Reputation

4 Anleitungen geschrieben

Team

Cal Poly, Team 13-8, Forte Fall 2014 Mitglied von Cal Poly, Team 13-8, Forte Fall 2014

CPSU-FORTE-F14S13G8

5 Mitglieder

5 Anleitungen geschrieben

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 308