Einleitung
This guide will demonstrate how to replace the Power Supply inside the Wii Balance Board.
Was du brauchst
-
-
Flip device upside-down so the plastic white board is facing the ground.
-
Locate the four feet in the corners of the Balance Board.
-
Unscrew the three 12.7 mm Phillips screws from each foot cover.
-
-
-
Remove the gray plastic ring from the actual foot by lifting it up.
-
-
-
Repeat steps two and three on the remaining four feet.
-
-
-
-
Locate the gray battery compartment.
-
Push the tab on the bottom and lift up completely to remove the cover to the batteries.
-
-
-
Unscrew the two 6.35 mm Phillips #1 screws.
-
Slide the battery case out.
-
-
-
Lift the frame, circuit board, and power supply out of the front case. These components are all connected.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 13-8, Forte Fall 2014 Mitglied von Cal Poly, Team 13-8, Forte Fall 2014
CPSU-FORTE-F14S13G8
5 Mitglieder
15 Anleitungen geschrieben
