Einleitung
Use this guide to replace the outer case on your Nintendo Wii U GamePad.
Was du brauchst
-
-
Face the GamePad down and unscrew the two Phillips #00 screws which are attached to the battery cover.
-
Lift up and remove the battery cover.
-
-
-
With your finger on the battery connector, pull downwards toward the base of the GamePad to disconnect it.
-
Pull upwards from the bottom of the battery to release it.
-
-
-
-
Remove the ten 8.9mm Tri-wing Y1 screws hidden underneath square stickers.
-
Lift up the back plate.
I feel like it’s important to mention how deep some of these holes are. Your screwdriver might not reach. Mine sure didn’t.
I had to shove some tissue into the screwdriver bit holder to get it to reach
-
-
-
Unplug the connector that connects the back plate to the motherboard.
-
Remove the back plate.
You don't have to remove just be careful
I tried to remove like at least 6 times but I wasn’t able to. Using tweezer, my nails, long nose pliers. There could be a lock but I gave up since I’m afraid if I put more force I might accidentally pull the wires. I’m able to remove the left and right analog stick with the back plate plugged, as mentioned, just be careful.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
11 weitere Nutzer:innen haben diese Anleitung absolviert.
2 Kommentare
and the front?