Einleitung

If the laser does not turn on and the batteries are good, this problem may be caused by a faulty wire. In order to replace a wire, follow the steps in this guide.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
    • Place the blaster upside down on the table, and remove the screw in the bottom of the handle.

    • Remove the battery door and take the batteries out.

    Kommentar hinzufügen

  2. Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.
    • Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.

    • Lift the side of the blaster off exposing its internal parts.

    Kommentar hinzufügen

    • Visually inspect all the wires in order to find the break, fray, or other problem.

    • Locate the end connections of the affected wire.

    Kommentar hinzufügen

    • Use a hot soldering iron to melt the solder at one end of the wire until the wire can be pulled free from the connection.

    • Repeat on the other end of the connection to remove the wire from the blaster.

    • (End points marked on image are for the black wire)

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Kyle Schober

Mitglied seit 24.02.2014

622 Reputation

5 Anleitungen geschrieben

Team

Michigan Tech, Team 5-8, Lauer Spring 2014 Mitglied von Michigan Tech, Team 5-8, Lauer Spring 2014

MTU-LAUER-S14S5G8

3 Mitglieder

9 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 3

Letzte 30 Tage: 9

Insgesamt: 494