X-street Lamborghini Murcielago LP670-4 SV Steering Column Spring Replacement

Einleitung

The steering column spring is responsible for reverting the wheels to a straight position when the remote is not turning one way or the other. A faulty steering column spring will fail to default to the straight position after turning the wheel.

Was du brauchst

Schritt 1 Battery

X-street Lamborghini Murcielago LP670-4 SV Steering Column Spring Replacement, Battery: Schritt 1, Bild 1 von 1

Unscrew the two 2.5mm Phillips #00 screws from the middle of the car.
Unclip the two clips to remove the battery cover.

Bearbeiten

Schritt 2

Unplug the battery by pushing on the clip.

Bearbeiten

Schritt 3 Underbody

X-street Lamborghini Murcielago LP670-4 SV Steering Column Spring Replacement, Underbody: Schritt 3, Bild 1 von 1

Unscrew the two 2.5mm Phillips #00 screws from each side

Bearbeiten

Schritt 4

Remove the side skirt covers on each side of the car.

Bearbeiten

Schritt 5

Lift up and remove the two side skirts.

Bearbeiten

Schritt 6

Unscrew the two 2.5mm Phillips #00 screws from the front skirt of the car.

Bearbeiten

Schritt 7

Lift the front part of the underbody and pull it out from the main underbody.

Bearbeiten

Schritt 8

Unscrew the remaining seven 9mm Phillips #00 screws from the underbody of the car.
The second image shows a closer view of the rear three screws

Bearbeiten

Schritt 9

Lift the main underbody from the shell of the car.
Lift up the body to expose the wiring and hardware underneath.

Bearbeiten

Schritt 10

Remove the reflective sticker from the top of the body.

Bearbeiten

Schritt 11

Unplug the wire connector.

Bearbeiten

Schritt 12 Steering Column

X-street Lamborghini Murcielago LP670-4 SV Steering Column Spring Replacement, Steering Column: Schritt 12, Bild 1 von 3

X-street Lamborghini Murcielago LP670-4 SV Steering Column Spring Replacement, Steering Column: Schritt 12, Bild 2 von 3

X-street Lamborghini Murcielago LP670-4 SV Steering Column Spring Replacement, Steering Column: Schritt 12, Bild 3 von 3

Unscrew the three 2.5mm Phillips #00 screws from the white steering column.
After removing the three screws, the steering column will pop out of position because of the springs underneath. To reassemble, put the springs back together as shown in picture #3.

Bearbeiten