Einleitung
This guide will teach you how to remove old or damaged strings from a Yamaha APX-6N guitar. It will also teach you how to put the new strings on properly and tie knots at the bridge and head so the strings stay in place.
Was du brauchst
-
-
Loosen the guitar strings by turning the tuning pegs counter clockwise.
-
-
-
Once the strings are loose, cut them using the wire cutters.
-
After strings have been cut, remove them by pulling them out of the tuners and the bottom of the bridge.
-
-
-
Insert the end of the string through the middle of the bridge until four inches comes through.
-
Wrap the short end of the string around the long end, making a loop.
-
Put the short end of the string through the loop around three to four times.
-
Pull both ends of the string until the knot is tight.
-
-
-
-
Insert the end of the string into the hole on the correct tuning peg.
-
Pull the end over the tuning peg and loop under the string. Then push the end of the string under the loop.
-
Put the end of the string through the loop and pull both ends until the knot is tight.
-
-
-
Repeat Step 4 for all other strings. Strings should be placed in the tuning pegs in clockwise order. Refer to string packaging for more details.
-
-
-
Turn the tuning pegs clockwise to tighten each string until the string makes a sound when plucked.
-
-
-
After all strings have been replaced, tune the guitar to your desired tuning.
-
Check the headstock and the bridge for any loose string ends.
-
If necessary, use the wire cutters to snip off excess string.
-
You now have new strings for your guitar!
You now have new strings for your guitar!
Team
York University, Team S1-G20, O'Regan Summer 2021 Mitglied von York University, Team S1-G20, O'Regan Summer 2021
YORK-O'REGAN-SU21S1G20
1 Mitglied
1 Anleitung geschrieben
