Einleitung

This is a guide to replace the legs of the Zoomer Meowzies. Removing the legs is a prerequisite to the replacment guides for the Infrared Sensors, LED Screen “Eyes,” and the Speaker.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Using the Triangle driver remove the four 7.5 mm screws.
    • Using the Triangle driver remove the four 7.5 mm screws.

    • The two front screws are deeper than the two on the back legs which may cause difficulties. These can be reached by putting the bit in first then carefully putting the driver on slightly (not all the way)

    Kommentar hinzufügen

  2. Kostenloser Versand bei Bestellungen über 20 $
    Verwende den Code BLUEANDBLACK an der Kasse
    Kostenloser Versand bei Bestellungen über 20 $
    Verwende den Code BLUEANDBLACK
  3. Turn the device so that the the device is on its side.
    • Turn the device so that the the device is on its side.

    • Hold the back and belly on the device and gently pull apart.

    • Pulling with too much force might damage a few cables inside, so caution is needed.

    Kommentar hinzufügen

    • With insides exposed, grab leg and gently pull up and away from the body to detach them. Repeat for all legs needed.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Muataz Alahmadi

Mitglied seit 14.02.2018

193 Reputation

2 Anleitungen geschrieben

Team

USF Tampa, Team S6-G2, Eyestone Spring 2018 Mitglied von USF Tampa, Team S6-G2, Eyestone Spring 2018

USFT-EYESTONE-S18S6G2

3 Mitglieder

8 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 1

Insgesamt: 35