Änderungen an Schritt Nr. 2

Bearbeitet von Christopher Hill -

Bearbeitung abgelehnt von Jake Devincenzi

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Disconnect the hard drive thermal sensor by pulling its connector toward the top of your iMac.
[* icon_note] When removing this connector, it is helpful use your thumbnails to push the ears on either side of the connector toward the top of your iMac.
[* black] It is also possible to remove the sticky-sponge holding the temp sensor to the hard drive instead of disconnecting it. When the new drive is in place just put the sponge/thermal sensor back on the new drive.