Änderungen an Schritt Nr. 2
Bearbeitet von Alden Glassey -
Bearbeitung genehmigt von Alden Glassey
- Vorher
- Nachher
- Unverändert
Schritt-Zeilen
| [* black] Use the screw driver with the 4.0 flathead bit to pry off the rubber bottom cover. It will be glued onto the bottom of the speaker. |
| [* black] Work the rubber cover off by slowly going all the way around applying as much force as needed. |
| [* icon_note] Since the cover is glued, a heat gun at low temperature or a hair dryer may be useful to speed up the process. However it is not required in this step. |