Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 3

Bearbeitet von Erik -

Wartet auf Freigabe

Vorher
Nachher
Unverändert

Schritt-Zeilen

[* black] Remove the following three Phillips screws securing the logic board to the rear panel:
[* orange] One 1.9 mm screw
[* red] Two 2.3 mm screws
[* icon_note] The darker screw belongs in the screw hole next to the dock connector.
+[* black] During reassembly, it is helpful to keep the two 2.3 mm headphone jack screws loose initially, plug in your headphones, and then proceed to tighten the screws fully while insuring that the unit is screwed on correctly (otherwise your headphones might stick out slanted).