Canon EOS 60D Rubber grips Replacement Schritt Nr.1 Verlauf

Änderungen an Schritt Nr. 1

Bearbeitet von Walter Galan – 4. Sep 2013

Bearbeitung genehmigt von Walter Galan

	[* black] Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.
	[* black] Repeat for the other two grips
	[* icon_note] The large one on the battery-side is the easiest to start with. This is required to remove the front & back panels
	[* icon_note] The small one on the back is a bit difficult to get started, but not really difficult to remove.
	[* icon_note] The one on the AV panel will be easier if you open up the AV port cover.
+	[* black] Remove the adhesive like you would rubber cement, just rub your finger against it, it will come off.
+	[* black] Optionally throw the balled up adhesive at people pretending its a booger :)