Änderungen an Schritt Nr. 2
Schritt-Zeilen
| + | [* black] Carefully remove your main board from the controller. Its not necessary to disconnect the two large ribbon that goes to the array of sensors. If you do be very careful. |
|---|---|
| + | [* black] Locate the 6 soldering pads at the bottom of the controller near the USB port. Solder a wire to the first pad top left. |
| + | [* black] Locate the 8 solder pads near the bottom left of the main board. Solder a wire to the top right pad. |
Bild 1
Kein vorheriges Bild
Hinzugefügt