Änderungen an Schritt Nr. 5
Bearbeitet von Victoria Yates –
Bearbeitung genehmigt von Victoria Yates
- Vorher
- Nachher
- Unverändert
Schritt-Zeilen
| [* black] ***Take up the slack on the shifter cable with pliers and tighten down the bolt on the retaining clamp.*** | |
| - | [* black] Thread the shift cable back into the derailleur, pull it tight and tighten the anchor bolt so the cable flattens. Then find a bare stretch of cable and give it a good pull to make sure the cable is seated and has no slack. Then loosen the cable, pull it tight again and re-tighten it. |
| - | [* black] While changing gears if you have to force them to change, the derailleur was put on incorrectly. The casing for your cables can break. |
| - | [* black] Run through the entire range of rear sprockets to make sure the chain does not rub on either side of the front derailleur cage. |
| + | [* black] Thread the shift cable back into the derailleur, pull it tight and tighten the anchor bolt so the cable flattens. Then find a bare stretch of cable and give it a good pull to make sure the cable is seated and has no slack. Then loosen the cable, pull it tight again and re-tighten it. |