Upgrade the display panel and replace the display cable Schritt Nr.2 Verlauf

Änderungen an Schritt Nr. 2

Bearbeitet von Roberto Bartolacci – 22. Jan 2020

Bearbeitung genehmigt von Roberto Bartolacci

	[title] Realease the fan
	[* black] Detach the adhesive stripe that secures the webcam and display cables to the fan.
-	[* yellow] Disconnect the fan's ribbon connector. [guide\|25629\|It would be ~~best~~ if you follow this method\|stepid=64970] but if you do not properly manage to grab the connector with your fingers, take two pairs of tweezers and grab the ~~four~~ wires as close as possible to the connector ─ as it is shown in ~~the second picture~~ ─ and pull them straight up ~~resolutely~~.
-	[* blue] Using a ~~PH #00~~ remove the two ~~screws (M2~~.5×4.5) and group them together.
-	[* violet] Using a ~~PH #00~~ remove the last ~~screw (M2~~.5×6.5) that secure the fan to the top cover. ~~Take notice of this screw~~ because it is longer than ~~the other two~~.
+	[* yellow] Disconnect the fan's ribbon connector. [guide\|25629\|It would be better if you would follow this method (step#2)\|stepid=64970] but if you do not properly manage to grab the connector with your fingers, take two pairs of tweezers and grab all the wires as close as possible to the connector ─ as it is shown in pic#2 ─ and resolutely pull them straight up.
+	[* blue] Using a PH#00 screwdriver remove the two Phillips PM2.5×4.5 screws and group them together.
+	[* violet] Using a PH#00 screwdriver remove the last Phillips PM2.5×6.5 screw that secure the fan to the top cover. ''Do not group it together with the two previous screws because it is longer than those.''