Änderungen an Schritt Nr. 22
Bearbeitet von Roberto Bartolacci –
Bearbeitung genehmigt von Roberto Bartolacci
- Vorher
- Nachher
- Unverändert
Schritt-Zeilen
| + | [title] Connect the new display cable to the new display |
|---|---|
| + | [* black] Now take the new display and the new display cable and lay the display panel over its packaging or any other soft layer you have at hand. ''The display front must be facing the table so that you have its connector in front of you. as it is shown in pic#1'' |
| + | [* blue] Grab the end of the cable with your fingers as you did to remove the old display cable, align it to the connector and straightly and forcefully push the cable inside. |
| + | [* icon_caution] *** STOP*** only when you see a flat full golden surfuace between the two parts. That is to say do not stop pushing when there are still black empty spaces as it is shown in pic#3. That was not enough. When I later switched on the laptop, the display was not working good! ''(I had to disassemble the display again & push the cable further inside)'' |
| + | [* icon_note] ''With high probability the connector will soflty move backwards a little while you are pushing the cable inside: it's ok, keep pushing it forcefully in order to connect them right. The connector will automatically come back when you stop pushing. '' |
Bild 1
Kein vorheriges Bild
Hinzugefügt
Bild 2
Kein vorheriges Bild
Hinzugefügt
Bild 3
Kein vorheriges Bild
Hinzugefügt