Repariere deine Sachen Community Shop

Änderungen an Schritt Nr. 22

Bearbeitet von Roberto Bartolacci –

Bearbeitung genehmigt von Roberto Bartolacci

Vorher
Nachher
Unverändert

Schritt-Zeilen

[title] Connect the new display cable to the new display
[* black] Lay the new display panel over its packaging ─ or any other soft layer you have at hand ─ with its front side facing the table so that you have the display connector in front of you, as in pic#1.
[* blue] Grab the end of the new cable with your fingers as you did with the old one, align it and push it inside the connector straightly and powerfully.
-[* icon_note] ''With high probability the connector will soflty move backwards a little while you are pushing the cable inside: it's ok, keep pushing it forcefully in order to connect them right. The connector will automatically come back when you stop pushing. ''
-[* icon_caution] *** STOP*** only when you see a flat full golden surfuace between the two parts. Do not stop pushing when there are still black empty spaces as it is shown in pic#3, that is not enough. When I later switched on the laptop, the display was not working good and I had to disassemble the bezel and the panel again to push the cable further inside.
+[* icon_note] ''With high probability the connector will softly move backwards a little while you are pushing the cable inside: it's ok, keep pushing it forcefully in order to connect them right. The connector will automatically come back when you stop pushing. ''
+[* icon_caution] *** STOP*** only when you see a flat full golden surface between the two parts. Do not stop pushing when there are still black empty spaces as it is shown in pic#3, that is not enough. When I later switched on the laptop, the display was not working good and I had to disassemble the bezel and the panel again to push the cable further inside.