Repariere deine Sachen Community Shop

Änderungen an Schritt Nr. 35

Bearbeitet von Roberto Bartolacci –

Bearbeitung genehmigt von Roberto Bartolacci

Vorher
Nachher
Unverändert

Schritt-Zeilen

[title] Reconnect the display cable to the mother board (2 of 2)
-[* orange] Lay the display cable end inside the connector. ''It is right positioned when its two indentations have passed the two small black "squares" at the edges of the ZIF connector and when the white line visually creates a single line with the latter ones. ''
-[* black] Then keeping the cable positioned with one hand, push down the locking flap of the connector using a spudger with the other hand. ''This operation has not to be done in one single movement. Start pressing in the middle of the flap. ''
-[* black] Once the flap of the connector is locked, reattach the adhesive tape, which is also helding two other wires, over the connector.
+[* orange] Lay the display cable's end inside the connector. ''It is rightly positioned when its two indentations match the two small black "squares" at the edges of the ZIF connector and when the white line visually creates a single line with the those "squares". ''
+[* black] Then, keeping the cable positioned with one hand, push the locking flap down using a spudger. ''This operation has ++not++ to be done in one single movement: start pressing the middle of the flap and evenly proceed with its edges. ''
+[* black] Once the flap of the connector is locked, reattach the adhesive tape over the connector. ''Mind the other two wires which it is also holding. ''