Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 4

Bearbeitet von Chris Maulino

Wartet auf Freigabe

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Flip over the optical drive casingenclosure. Use a spudger or your finger to lift the latches and disconnect the four ribbon cables on the edges of the board.
[* yellow] Using a Phillips #00 screwdriver, removeRemove the topthree screws on the board.
[* icon_caution] Do not remove the screws marked in blue
board with a Phillips #00 screwdriver.
[* red] Remove the two silver screws on the bottom of the case. These screws are different from the ones on the board and should be kept separate.
[* icon_note] Note: The longest screwof these two screws holds a metal tabtab as seen in the third picture.
[* black] Flip over the optical drive casingenclosure. Use a spudger or your finger to lift the latches and disconnect the four ribbon cables on the edges of the board.
[* yellow] Using a Phillips #00 screwdriver, removeRemove the topthree screws on the board.
[* icon_caution] Do not remove the screws marked in blue
board with a Phillips #00 screwdriver.
[* red] Remove the two silver screws on the bottom of the case. These screws are different from the ones on the board and should be kept separate.
[* icon_note] Note: The longest screwof these two screws holds a metal tabtab as seen in the third picture.

Bild 1

Alte Version

Neue Version

Bild 2

Alte Version

Neue Version