Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 4

Bearbeitet von jamak

Wartet auf Freigabe

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Flip over the optical drive enclosure. UseThere are four ribbon cables connecting the optical drive to a circuit board. Using a spudger or your finger tofinger, lift the latcheseach ribbon cable latch and disconnect the foureach ribbon cables on the edges of the boardcable.
[* black] Flip over the optical drive enclosure. UseThere are four ribbon cables connecting the optical drive to a circuit board. Using a spudger or your finger tofinger, lift the latcheseach ribbon cable latch and disconnect the foureach ribbon cables on the edges of the boardcable.
[* yellow] Remove the three screws on the board with a Phillips #00 screwdriver.
[* red] Remove the two silver screws on the bottom of the case. These screws are different from the ones on the board and should be kept separate.
[* icon_note] Note: The longestlonger of these two screws holds down a metal tab that comes loose as seen in the third picture.
[* icon_note] Note: The longestlonger of these two screws holds down a metal tab that comes loose as seen in the third picture.