Skip to main content

Änderungen an Schritt Nr. 4

Bearbeitet von jamak

Wartet auf Freigabe

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Flip over the optical drive enclosure. There are four ribbon cables connectingconnected to the optical drive to a circuit board. Using a spudger or your finger, lift each ribbon cable latch and disconnect each ribbon cable.
[* black] Flip over the optical drive enclosure. There are four ribbon cables connectingconnected to the optical drive to a circuit board. Using a spudger or your finger, lift each ribbon cable latch and disconnect each ribbon cable.
[* yellow] Remove the three screws on the board with a Phillips #00 screwdriver.
[* red] Remove the two silver screws on the bottom of the case. These screws are different from the ones on the board and should be kept separate.
[* icon_note] Note: The longer of these two screws holds down a metal tab that comes loose as seen in the third picture.