Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 6

Bearbeitet von jamak

Wartet auf Freigabe

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Flip over the drive so that the circuit board is on the bottom and the optical sensor is on top.
[* blackyellow] Remove the screw holdingthat downs the the optical sensorsensor using a Torx T10 screwdriver.
[* icon_note] Note: Take offThere is tape on the red and black wires that must be removed to separate the optical sensor.
[* icon_caution] The wires on the optical sensor are very weak. They will break easily if muchexcessive force is applied to them.
[* red] Remove the four black screws on the edges of the case (Image 3)case.
[* icon_remindericon_note] After taking out the screws, you don't have to open the case just yet.
[* black] Flip over the drive so that the circuit board is on the bottom and the optical sensor is on top.
[* blackyellow] Remove the screw holdingthat downs the the optical sensorsensor using a Torx T10 screwdriver.
[* icon_note] Note: Take offThere is tape on the red and black wires that must be removed to separate the optical sensor.
[* icon_caution] The wires on the optical sensor are very weak. They will break easily if muchexcessive force is applied to them.
[* red] Remove the four black screws on the edges of the case (Image 3)case.
[* icon_remindericon_note] After taking out the screws, you don't have to open the case just yet.

Bild 2

Alte Version

Neue Version