Skip to main content

Änderungen an Schritt Nr. 6

Bearbeitet von Sterling Hirsh ENGL 149

Wartet auf Freigabe

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Flip casethe drive so that the removed partcircuit board on the bottom and the optical sensor is facing upon top.
[* black] Flip casethe drive so that the removed partcircuit board on the bottom and the optical sensor is facing upon top.
[* black] Remove screw holding the optical sensor.
[* icon_note] Note: Take off tape on the wires to separate optical sensor.
[* black [* icon_caution] The wires on the optical sensor are very weak. They will break easily if much force is applied to them.
[* red
] Remove the four black screws on the edges of the casecase (Image 3).
[* icon_reminder] After taking out the screwsscrews, you don't have to open the case just yet.
[* black [* icon_caution] The wires on the optical sensor are very weak. They will break easily if much force is applied to them.
[* red
] Remove the four black screws on the edges of the casecase (Image 3).
[* icon_reminder] After taking out the screwsscrews, you don't have to open the case just yet.