Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 6

Bearbeitet von jamak

Wartet auf Freigabe

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Flip over the enclosure so that the circuit board is on the bottom and the optical sensor is on top.
[* yellow] Remove the screw that downs the the optical sensor using a Torx T10Phillips #00 screwdriver.
[* yellow] Remove the screw that downs the the optical sensor using a Torx T10Phillips #00 screwdriver.
[* icon_note] Note: There is tape on the red and black wires that must be removed to separate the optical sensor.
[* icon_caution] The wires on the optical sensor are very weak. They will break easily if excessive force is applied to them.
[* red] Remove the four black screws on the edges of the caseenclosure using a Phillips #00 screwdriver.
[* icon_note] After taking out the screws, you don't have to open the caseenclosure just yet.
[* red] Remove the four black screws on the edges of the caseenclosure using a Phillips #00 screwdriver.
[* icon_note] After taking out the screws, you don't have to open the caseenclosure just yet.