Änderungen an diesem Schritt
Bearbeitet von Thomas J –
- Vorher
- Nachher
- Unverändert
Schritt-Zeilen
| - | [* black] If can't find anything suitable in the internet, I'll give you a few tips how to build a screwdriver on your own. |
|---|---|
| - | [* black] Use a steel rod of about 8 mm diameter. Don't use any weaker metals |
| - | [* black] Now try to mill three teeth with equivalent distanze around the boundary of one end of the rod with an angle grinder. After you made this drill a hole perpendicularly in the center of the rod. |
| - | [* black] With some talent you should now have a reasonable screwdriver for the four most terrible screws I've ever seen. |
| - | [* black] Now can start with the actual teardown. |
| + | [* black] I couldn't find anything suitable in the internet, so I built one on my own in this way: |
| + | [* black] Using a steel rod of about 8 mm diameter. |
| + | [* black] I tried to mill three teeth with equivalent distance around the boundary of one end of the rod with an angle grinder. After that I drilled a hole perpendicularly in the center of the rod. Taddaah... a working screwdriver! |
| + | [* black] Now let's begin the Teardown. |