Repariere deine Sachen Community Store

Änderungen an Schritt Nr. 15

Bearbeitet von Spencer Pennington –

Bearbeitung genehmigt von Spencer Pennington

Vorher
Nachher
Unverändert

Schritt-Zeilen

-[* icon_caution] The screws in this step have different threads. Keep close track of where screws go to avoid stripping the screw wells.
-[* black] Use a Phillips screwdriver to remove eight screws from the right end of the Cricut:
- [* red] Two 10.2 mm‑long [link|https://guide-images.cdn.ifixit.com/igi/JtDTFFbAeHngjqcb.full|screws|new_window=true] securing the right end top metal track, which include a washer and a locking washer.
+[* icon_caution] The screws in this step have different threads. Keep close track of where the screws go to avoid stripping the screw wells.
+[* black] Use a Phillips screwdriver to remove eight screws from the right side of the Cricut:
+ [* red] Two 10.2 mm‑long screws securing the right end top metal track, which include [link|https://guide-images.cdn.ifixit.com/igi/JtDTFFbAeHngjqcb.full|a washer and a locking washer|new_window=true].
[* orange] Four 10.0 mm‑long [link|https://guide-images.cdn.ifixit.com/igi/ot1N6pqk4OOCEUZD.full|screws|new_window=true] securing the large white plastic bracket.
- [* yellow] Two 7.9 mm‑long [link|https://guide-images.cdn.ifixit.com/igi/w5RvlMOMHsYHCeHM.full|screws|new_window=true] securing the large white plastic bracket, which include white plastic spacers.
+ [* yellow] Two 7.9 mm‑long screws securing the large white plastic bracket, which include [link|https://guide-images.cdn.ifixit.com/igi/w5RvlMOMHsYHCeHM.full|white plastic spacers|new_window=true].
[* icon_reminder] During reassembly:
- [* black] Check that the tool holder slides freely with the top metal track fully seated before replacing any screws. If it does not, you may need to tilt the top of the tool holder forwards slightly so it is completely in the top track.
+ [* black] Check that the tool holder slides freely with the top metal track fully seated before re-installing any screws. If it doesn't, you may need to tilt the top of the tool holder forwards slightly so it's completely in the top track.
[* black] Reconnect the [link|https://guide-images.cdn.ifixit.com/igi/1VoGESevcWPYCQRe.full|motor ground wire|new_window=true] to the right-most screw that secures the right end of the top metal track.