Änderungen an Schritt Nr. 3
Bearbeitet von Dave Empson –
Bearbeitung genehmigt von Dave Empson
- Vorher
- Nachher
- Unverändert
Schritt-Zeilen
| - | [* black] Cleaning the contacts in the previous step did not work, remove the 13 screws to split the lid in two as shown in the image and replace the lid (with mains turn off!) |
|---|---|
| - | [* black] With a multimeter, measure the resistance between the two terminals marked with green arrows. It should be about 60ohms. If it is not then, either the contacts in the previous step have not been cleaned enough or there is a break in the circuit due to a failed thermal fuse, thermostat or heating element. which requires further investigation. |
| + | [* black] If cleaning the contacts in the previous step did not work, remove the 13 screws to split the lid in two as shown in the image and replace the lid (with mains turn off!) |
| + | [* black] With a multimeter, measure the resistance between the two terminals marked with green arrows. It should be about 60ohms. |
| + | [* black] If the resistance is much higher then either the contacts need more cleaning, or the thermal fuse/ heating element has failed (not covered by this simple guide) |