Änderungen an Schritt Nr. 1
Bearbeitet von Sam Goldheart –
Bearbeitung genehmigt von Sam Goldheart
- Vorher
- Nachher
- Unverändert
Schritt-Zeilen
| - | [* black] Insert wisdom here. |
|---|---|
| + | [* black] Got a small aluminum piece from a used Mac battery A1175 |
| + | [* black] Grind both upper and lower side off the piece so it fit just against the right wall off MacBook |
| + | [* black] Drilled Ø 4 mm (better measure your own piece) and glued with cyanoacrylate the very far of the small metal tab. |
| + | [* black] Get a push-button small enough to fit below the mother board (beware of a thick piece (maybe transformer)) that can avoid placing your switch. My switch come from www.conrad.fr with ref n° 705325 (perfect fit at the chosen place) |
| + | [* black] Solder two thin wire ~ 4cm very close to the switch body, routing them so they don't touch the motherboard. |