Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 4

Bearbeitet von Ben Clough -

Bearbeitung genehmigt von Ben Clough



[* black] Once the button to replace has been identified, flip the board over so that the green side is face up.
[* black] Position the circuit board so that it will be easy to use a soldering iron on.
[* red] Heat the connections of the button to replace with the soldering iron until all solder is removed. Then pull the button from the board.
[* red] Replace the button with a new, working button and apply new solder with the soldering iron to the connections in back.
[* icon_note] Each button has a total of four connectors to remove/solder.
[* icon_caution] Ensure that the old solder is completely removed from the board to prevent any electrical shorts when the new button is connected.

Bild 1

Kein vorheriges Bild