Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur


Änderungen an Schritt Nr. 7

Bearbeitet von Evan Noronha -

Bearbeitung genehmigt von Evan Noronha



[title] Desolder Components from Flight Controller
[* black] Use a soldering iron and solder wick to desolder the four motors and four LEDs from the control board.
[* black] If the connection holds even after removing the solder from the joint, gently pull up on the wire while applying heat to the joint until the wire separates from the PCB
[* black] In this step you are disconnecting a total of 16 wires from the board
[* black] CAUTION: Overheating the PCB can damage the traces, making it difficult or impossible to reconnect the components later on. Do not apply too much heat to the board; these traces are especially delicate due to their size.