Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 7

Bearbeitet von Evan Noronha -

Bearbeitung genehmigt von Evan Noronha

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[title] Desolder Motors from Flight Controller
[* black] Use a soldering iron and solder wick to desolder the four motors from the control board.
[* black] If the connection holds even after removing the solder from the joint, gently pull up on the wire while applying heat to the joint until the wire separates from the PCB
[* black] In this step youThe motor wires are disconnecting a total of eight wiresin either black-white or red-blue pairs.
[* black] In this step youThe motor wires are disconnecting a total of eight wiresin either black-white or red-blue pairs.
[* black] CAUTION: Overheating the PCB can damage the traces, making it difficult or impossible to reconnect the components later on. Do not apply too much heat to the board; these traces are especially delicate due to their size.
[* black] VIDEO COMING SOON: It appears my video does not meet the iFixit timing requirements. I will edit it down and upload shortly.