Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 3

Bearbeitet von aaron thielk -

Wartet auf Freigabe

Vorher
Nachher
Unverändert

Schritt-Zeilen

[* black] Select the appropriate spoke wrench to tighten or loosen the spoke.
-[* black] On high points loosen the closest spokes to the point of contact and tighten the spokes on the opposite side.
-[* black] Start by loosening the spoke closest to the high point then loosening the spokes next to it 1/2 a turn. then tighten in the same manner for the opposite side e
+[* black] Loosen the spokes that pull the rim to far and tighten the spokes on the opposite side to shift the rim over to the center. 1/2 of a turn with the spoke wrench is a good starting point.
+[* black] In the example we are tightening the red marked spokes and loosening the blue marked spokes. This will shift the rim closer to the viewer.
+[* black] Spin the wheel to check if the rim is straighter. Repeat the process for further out of roundness.

Bild 1

Alte Version

Neue Version

Bild 2

Alte Version

Neue Version