Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 3

Bearbeitet von Jonathan Fish -

Wartet auf Freigabe

Vorher
Nachher
Unverändert

Schritt-Zeilen

[* black] Select the appropriate spoke wrench to tighten or loosen the spoke.
-[* black] Loosen the spokes that pull the rim to far and tighten the spokes on the opposite side to shift the rim over to the center. 1/2 of a turn with the spoke wrench is a good starting point.
+[* black] Loosen the spokes that attach to the same side of the wheel as the caliper contact point. At the same time, tighten the spokes that attach to the opposite side of the wheel as the caliper contact point. To start, try a half turn for each of the spokes near the caliper contact point.
[* black] In the example we are tightening the red marked spokes and loosening the blue marked spokes. This will shift the rim closer to the viewer.
-[* black] Spin the wheel to check if the rim is straighter. Repeat the process for further out of roundness.
+[* black] Spin the wheel. Tighten the calipers again until they touch the rim on only one side at a time at certain point. Repeat steps 2-3 until when tightening the calipers, they touch both sides of the rim evenly at every point on the rim.