Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 7

Bearbeitet von John -

Wartet auf Freigabe



-[* black] Insert wisdom here.
+[* black] Use a heat gun to shrink the heat shrink over the joint.
+[* black] If you are using electrical tape, start a small loop around the joint.
+ [* black] It's hard to fit the entire roll of tape through the space between the wires, so pull off some tape then tear it off the roll.
+ [* black] Wrap the entire joint in electrical tape. I always use a double layer, going up the joint one way, then back down to where I started.