Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 4

Bearbeitet von Jeff Suovanen -

Bearbeitung genehmigt von Jeff Suovanen

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Place the leads of the resistor through the holes on either side of the rectangle marked '''R1''' on the circuit board.
[* icon_note] Resistors do not have to be installed in a particular orientation. Either lead can go into either hole.
[* black] Turn the board over so that the copper traces are facing up and the resistor leads are pointing straight up in the air, as seen in the second picturepicture.
[* black] Turn the board over so that the copper traces are facing up and the resistor leads are pointing straight up in the air, as seen in the second picturepicture.
[* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30° down from vertical is acceptable.